Product Info
Table Of Contents
- Commissioning
- 1 About this document
- 2 Commissioning software overview
- 3 Preparing for commissioning
- 4 Getting started with BTS Manager
- 5 Commissioning Wizard process
- 6 Traffic Manager
- 7 Line interface and synchronization settings
- 8 Radio Wizard
- 9 Cross-connections
- 10 Commissioning Report
- 11 Troubleshooting and fault reporting
- Appendix A. LMP connector description
Commissioning
30 (78) © Nokia Corporation Draft DN999099
Nokia Proprietary and Confidential Issue 4-0 en
Note
Note
Figure 5. The Set Transmission Parameters wizard page of Nokia BTS
Manager’s Commissioning Wizard
Click SYNCHRONIZATION to check the synchronization settings.
Modify the settings, if necessary, and click OK. See Chapter 7.2 for more
information.
There are no synchronization settings for the FC RRI unit because the only
available timing option for that unit is Rx Clock. If the transmission unit in the
BTS configuration is FC RRI and you click the Synchronization button, a check
mark appears in the ‘Checked’ check box, and the NEXT button becomes enabled
(if you have already checked the LIF settings).
The NEXT button remains disabled until you have checked the LIF and
synchronization settings.
Click NEXT after you have checked the parameters.