Product Info
Table Of Contents
- Commissioning
- 1 About this document
- 2 Commissioning software overview
- 3 Preparing for commissioning
- 4 Getting started with BTS Manager
- 5 Commissioning Wizard process
- 6 Traffic Manager
- 7 Line interface and synchronization settings
- 8 Radio Wizard
- 9 Cross-connections
- 10 Commissioning Report
- 11 Troubleshooting and fault reporting
- Appendix A. LMP connector description
Preparing for commissioning
DN999099 © Nokia Corporation Draft 19 (78)
Issue 4-0 en Nokia Proprietary and Confidential
Note
Note
3 Preparing for commissioning
Before starting BTS commissioning, complete the following procedure.
Preparing for commissioning:
1. Check that the Abis cables are connected on the BTS.
Commissioning can be performed without the BSC connection (Abis cables
disconnected, for example). For more information, see Step 7 in the
commissioning procedure in Chapter 5.
2. Check that the Nokia MetroSite EDGE Base Station is powered up.
3. Connect the Nokia BTS Manager PC to the BTS’s LMP port. See
Appendix A for a description of the LMP cable.
4. Check that you have the required Site IDs (optional) and transmission
capacity tables.
BTS SW is loaded to the BTS by the manufacturer at the factory. There is no need
to locally load SW to the BTS before commissioning. If the BTS SW is different
from the SW at the BSC, it will be loaded automatically to the BTS during the
commissioning procedure.