Product Info
Table Of Contents
- Commissioning
- 1 About this document
- 2 Commissioning software overview
- 3 Preparing for commissioning
- 4 Getting started with BTS Manager
- 5 Commissioning Wizard process
- 6 Traffic Manager
- 7 Line interface and synchronization settings
- 8 Radio Wizard
- 9 Cross-connections
- 10 Commissioning Report
- 11 Troubleshooting and fault reporting
- Appendix A. LMP connector description
Commissioning software overview
DN999099 © Nokia Corporation Draft 15 (78)
Issue 4-0 en Nokia Proprietary and Confidential
2 Commissioning software overview
The Nokia MetroSite EDGE Base Station is configured in the network with Nokia
SiteWizard software for GSM and/or GSM/EDGE with Nokia SiteWizard
software, version 3.0 or later. BTS commissioning is done locally at the BTS
using SiteWizard’s BTS Manager software.
The appropriate CX software packages for the BTS’s configuration are loaded to
the master TRX at the factory or from the BSC. For EDGE transmission, CX 3.2
or later is required. These software packages are downloaded locally using Nokia
BTS Manager during commissioning, or remotely from the BSC.
After commissioning, the BTS is normally managed remotely from the OSS via
the BSC, although O&M tasks can also be done locally with BTS Manager.
2.1 Nokia SiteWizard 3.0
Nokia SiteWizard contains all the manager software required for commissioning
a BTS and any transmission equipment that is connected to it.
Table shows the contents of Nokia SiteWizard version 3.0. For more information
on the features of the software, see the Software Release Binder delivered with
Nokia SiteWizard.
Included managers and
files
Version
BTS Manager 3.0
Site HW configurator 2.0
MetroHub Manager 2.0.5
E1/T1 Manager 3.0.4
RRI Manager 3.0.10
UltraSite BTS Hub Manager C1.2