Product Info

Solution Accessories
64 (66) © Nokia Corporation Draft DN99252966
Nokia Proprietary and Confidential Issue3-0en
Note
6. Undo each plug connector screw sufficiently to enable the cable wire to be
inserted and insert the wires in each connector.
The brown (live) wire to be inserted in the right-hand connector as viewed from
the front. The blue (neutral) wire is inserted into the left-hand connector, and the
yellow/green (earth) wire to the centre connector.
7. Tighten each screw in turn to fix the wires in the connectors.
8. Align the sleeve on the cable so that the raised end can be inserted into the
slot.
9. Place the two body parts together, making sure they are aligned, the wires
are clear of the body fixing hole and the sleeve is properly located in the
slot.
10. Fix the body parts together with the screw, nut and washer.
11. This procedure is to be repeated for the other end of the cable if the power
cable is to connect the MetroSite BBU to a MetroSite BTS.
If the cable is to be connected to a MetroHub, repeat steps 1 and 2 for the
other end of the cable. Connect that end to the MetroHub as described in
the MetroHub User Manual (Installation).
If the cable is to be connected to the mains power source then this is user
defined.
Attachment 4: Installation instructions for the DC power plug for Nokia
MetroSite
The power feeder is a flexible rubber insulated cable with three multi-wire
conductors having dimensions of: 1.5 mm
2
or 2.5 mm
2
(AWG 15.5-13.5).