User's Manual

Commissioning

NTC DN999099 © Nokia Telecommunications Oy Internal Copy 15 (34)

Issue 1 en DRAFT 3 DraftConfidential

Note

Figure 3. EAC inputs

If the EAC outputs will not be used, click Next.

7. Check the EAC outputs (if they will be used) by changing the EAC states.

If the SCF is available and the EACs are defined in it, the EAC output

information is read from the SCF; otherwise you have to first mark the

required EACs as ‘In use’.

When you have finished the EAC output settings, click the Set Outputs

button to send the information to ther BTS.

After you have completed checking, click Next.

The Next button remains disabled until you click a check mark in the Checked

box for all outputs that are ‘In Use’.

The EAC names and polarities are defined at the BSC.