User's Manual

Ethernet Cabling Installation Chapter 4: Access P oint Hardw are Installation
Ethernet Cabling Installation
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Objective
This section contains the procedure for installing the Ethernet cables.
Cable Description
Cable J as listed in T able 3 -1 is required for installation.
Installing Ethernet Cables
F ollow the steps in Procedure 4 -11 to install the ethernet cables.
Procedure 4 -11 Procedure to Install Ethernet Cables
1
If not already done , remove conduit plug at the bottom of the B CU .
2
If Ethernet cables are not present, route
one end to Site T ermination Equipment.
If Ethernet cables are present, route them through conduit
and through access hole in the bottom of the B CU .
3
Insert cable connectors in the sockets labeled ENET A and ENET B.
4
If there are no more cables to connect close and lock Customer Interface
compartment.
Figure 4 -15 Ethernet Cable Connection
ti-cdma-04184.eps
ENET - A
ENET - A
ENET - B
ENET - B
4 -32 68P09277A59 -8
PRELIMINARY - UNDER DEVELOPMENT MA Y 2007