User's Manual
Local GPS Cabling Installation Chapter 4: Access P oint Hardw are Installation
Procedure 4 -10 Procedure for Installing Local GPS Antenna and Cabling (Continued)
3
The roof structure on which the mounting pole is attached should be
v eried b y a qualied structur al engineer for the weight of the Local
GPS engine and mounting hardw are or under adv erse conditions
for the installation area
Mounting the Local GPS antenna and hardware to an inadequate roof surface
and/or using inadequate installation methods can result in serious injury .
4
A ttach the Local GPS antenna assembly to the mounting bracket and secure
washer and custom nut supplied. See Figure 4-14
5
A ttach the grounding kit to the mounting pole with u-bolts and secure using
washers and nuts supplied. See Figure 4-14
6
Connect one (1) N connector of the 50 feet superflex cable to the N jack of the
RF GPS antenna cable (K) and route the other end of the cable down to the
B CU . Make allowances for strain relief .
7
Route the cable to the underside of the B CU to surge
arrestor connector (in Customer Interface Compartment).
Connect RF GPS cable between RF GPS Module and top of surge arrestor .
Continued
4 -30 68P09277A59 -8
PRELIMINARY - UNDER DEVELOPMENT MA Y 2007