User's Manual

Access P oint Hardw are Installation Local GPS Cabling Installation
Local GPS Cabling Installation
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Objective
The objective of this procedure is to install the Local (RF) Global P ositioning System (RF GPS)
cabling.
Tools and Materials
provides the quantities and descriptions of the cables.
• 5/16 Breakaway T orque W rench 9 -in. lb
• Adjustable T orque R atchet with metric socket set
• Flathead screwdriver
• N -SMA Adapter
Cable Description
Cable K as listed in T able 3 -1 is required for installation.
Surge Arrestor Installation
P erform the procedure in Procedure 4 -9 to install the surge arrestor .
Procedure 4 -9 Procedure to Install Surge Arrestor
1
Open Base Control Unit (B CU) Customer Interface Compartment.
2
V erify that surge arrestor is already installed. If not, then remove surge
arrestor from kit.
3
Install surge arrestor in the right side bottom of Customer Interface
Compartment, see Figure 4-13 .
4
A ttaching the ground cable is optional.
If not provided, perform the following to make
the ground cable for the surge arrestor .
Get two lug nuts.
Continued
68P09277A59 -8 4 -27
PRELIMINARY - UNDER DEVELOPMENT MA Y 2007