User's Manual

Base Control Unit Installation Chapter 4: Access P oint Hardw are Installation
Procedure 4 -5 Installing the Plinth on a R aised Platform or R oof T op (Continued)
8
B CU is ready for cabling. Proceed to Procedure 4-6
Figure 4 -9 Mounting Bolt Congur ation (R aised Platform or R oof T op)
ti-cdma-05743.eps
SMALL FLAT
WASHER
ROOFTOP
M12 X 100 BOL T
INSULATING WASHER
(OPTIONAL)
LARGE FLAT
WASHER
PLINTH MOUNTING
BRACKET
ISOLATION
PAD
MOUNTING
STRUCTURE
(I BEAM)
M12 NUT
LOCK WASHER
SMALL FLAT
WASHER
(AFFIXED TO
BRACKETS)
BCU Cable Installation
P erform the procedure in Procedure 4 -6 to install the B CU cables.
Procedure 4 -6 BCU Cabling Procedures
Continued
4 -20 68P09277A59 -8
PRELIMINARY - UNDER DEVELOPMENT MA Y 2007