User's Manual

Access P oint Hardw are Installation RF Head DC P ower Cabling Installation
RF Head DC Power Cabling Installation
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Objective
This section contains the procedure for installing the RF Head DC power cables.
DC Cable Description
Cable G listed in T able 3 -1 is required for installation
Tools Required
The following tools are required to install the DC P ower cables.
RF Head DC Power Cable Installation
F ollow the steps in Procedure 4 -14 to install the RF Head DC P ower Cables.
Procedure 4 -14 Procedure to Install RF Head DC P ower Cables
1
If not already open, open the B CU Customer Interface compartment.
2
Before routing DC power cable, verify that it is properly color coded. If more
than one RF Head in use, ensure that they are all properly color coded. The
colors are as follows:
• RFU 1 = RED
• RFU 2 = BL UE
• RFU 3 = YELLOW
• RFU 4 = GREEN
Color coded labels and tie-wraps can be found on the compartment
side of the door of the B CU Customer Interface Compartment.
Tie-wraps should be attached near the DC P ower cable connector .
Continued
68P09277A59 -8 4 -41
PRELIMINARY - UNDER DEVELOPMENT MA Y 2007