User's Manual

Access P oint Hardw are Installation MMI Cable F abrication
Figure C -1 F abricated MMI Cable Details
ti-cdma-00133.eps
1 3 5 7
2 4 6 8
8-Contact MMI Plug
Socket Numbering
(Mating Side)
12345
6789
DB-9 Plug
Socket Numbering
(Mating Side)
FABRICATION NOTES:
1. Separate wires at unterminated end of ribbon cable as required to connect to DB-9
connector contacts
2. Dark wire on ribbon cable of cable assembly 3009786R01 connects to pin 1 of the
8-contact plug
3. Strip three ribbon cable wires with connections specified in and connect to
DB-9 plug contacts as specified in Table C-2
4. Shorten un-connected ribbon cable wires enough to prevent contacting DB-9
contacts, leaving enough wire to engage any strain relief in the DB-9 connector shell
Item B
Wire Run List
T able C -2 provides the wire run/pin -out information MMI cable.
Table C -2 F abricated MMI Cable Wire R un List
8-CONT ACT MMI PLUG
CONT ACT
DB-9 PLUG
CONT ACT
1 NC
2 NC
3 NC
Common 4
– — — — — — — — —
5
RxD 5
— — — — — — — —
2
TxD 6
— — — — — — — —
3
7
NC
8 NC
68P09277A59 -8 C -1
MA Y 2007 PRELIMINARY - UNDER DEVELOPMENT