User's Manual

RGPS Cabling Installation Appendix B: Alternate RGPS Installation
RGPS Cabling Installation
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Objective
This section contains procedures for installing the Remote Global P ositioning System (RGPS).
Cable Description
Cables C and L as listed in T able 3 -1 are required for installation.
Tools Required
The following tools are required for RGPS installation.
• Flat blade screw driver
Cable Pinout
Figure B -1 Connector Pins Numbering for Cables C and L
ti-cdma-04196.eps
1
2
3
4
5
6
7
8
9
10
11 12
CONNECTOR FOR CABLE C
PIN 1
CONNECTOR FOR CABLE C1
PIN 9
B -2 68P09277A59 -8
PRELIMINARY - UNDER DEVELOPMENT MA Y 2007