User's Manual

What ’ s Next Chapter 6: What ’ s Next and Cleanup

What’s Next

■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■

■

Introduction

Optimization is the next procedure you should perform. There are two things left to do before

you begin the optimization:

1. Clean up the site

2. Fill out the installation completion checklist

Clean Up Site

Clean up the site by following the information given in the

Site Cleanup

area in this chapter .

Fill Out Checklist

A fter the site is cleaned up, ﬁll out the installation completion checklist. This checklist is located

in the

Installation Completion Checklist

area of this chapter .

Optimize the System

Optimize the system by following the procedures given in the appropriate optimization manual.

The hardware installation does not include card placement and turning on power . These things

and more are covered in the appropriate optimization manual.

6 -2 68P09277A59 -8

PRELIMINARY - UNDER DEVELOPMENT MA Y 2007