User's Manual

Access P oint Hardw are Installation Div ersit y Access P oint (DAP) RF Head Assembly Installation
Diversity Access Point (DAP) RF Head Assembly
Installation
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Overview
This section contains the procedures for installing the Diversity Access P oint RF Head Assembly
which is comprised of the RF Head and antenna radome. Refer to Figure 1 -2 for an overall
view of the DAP .
DAP RF Head
Refer to Figure 1 -4 for the major components of the DAP RF Head.
Electrical Requirements
The RF Head is designed to use 40 to 59 VDC (nominal +54 VDC) supplied through the Base
Control Unit (B CU).
Environmental
The operational temperature range for the RF Head is –20 to +55 degrees centigrade.
Dimensions and Weight
• Dimension: 228.6 mm (9 in) W x 712 mm (28 in) H x 406.4 mm (16 in) D
• W eight: 25.4 kg (56 lbs)
The dimension measurements do not include connectors, hinges, handles, or latches.
Conduit Sizes
Refer to T able 4 -2 for conduit sizes.
68P09277A59 -8 4 -35
PRELIMINARY - UNDER DEVELOPMENT MA Y 2007