User's Manual

RF Head Ground Cabling Installation Chapter 4: Access P oint Hardw are Installation
RF Head Ground Cabling Installation
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
The RF Head comes with a ground lug attached, but no ground wire.
F ollow the procedure in
Procedure 4 -15 RF Head Ground Cable Installation
1
Use a 10 mm socket wrench to loosen ground lug captive screws on RF Head.
2
Remove ground lug.
3
Slide a 6 A WG wire into the ground lug.
Crimp ground lug onto wire.
V erify that 6 A WG wire is secure within ground
lug.
4
Reattach ground lug onto RF Head.
Use a 10 mm socket wrench to tighten
captive screws. T orque to 45 in-lbs (5.0 N-m).
Secure opposite other end of ground wire to tower ground.
4 -44 68P09277A59 -8
PRELIMINARY - UNDER DEVELOPMENT MA Y 2007