User's Manual

Antenna Cable Chapter 3: Cable Descriptions
Antenna Cable
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Objective
This section contains general information on the antenna cabling.
Cable Label
Refer to T able 3 -1 for the labels used to identify the cables that will be shown in illustrations
throughout this chapter .
Table 3 -4 Cable Description and P art Numbers
Cable Qty
Part Number Description
B
2 – 4 3089492T02
Antenna Cable, 300 mm (1 ft.)
Antenna Cable Pin and Signal Information
The antenna cabling uses a 50 -Ohm coaxial cable. The inner conductor provides signaling and
the outer conductor provides shielding and ground.
Table 3 -5 Pin and Signal Information for Antenna Cable
Antenna
Inner Conductor Outer Conductor
B TX/RX
Ground
3 -10 68P09277A59 -8
PRELIMINARY - UNDER DEVELOPMENT MA Y 2007