User's Manual

Ground Based Access P oint (GAP) Hardw are Installation Mounting and bolt congur ations
Due to the weight of the GAP components and r ack, the supporting structure (oor
deck) must be able to withstand at least 1000 lbs (500 kg). A structur al oor support,
such as an iron I -beam, underneath the wooden oor is recommended.
Refer to Figure 4 -2 for a typical cross - section of the wooden floor bolt mounting to the GAP
cabinet or rack mounting brackets.
Figure 4 -2 W ooden oor mounting
ti-cdma-05743-wd.eps
SMALL FLAT
WASHER
M12 X 100 BOL T
INSULATING WASHER
(OPTIONAL)
LARGE FLAT
WASHER
MOUTING
BRACKET
ISOLATION
PAD
MOUNTING
STRUCTURE
(I BEAM)
M12 NUT
LOCK WASHER
SMALL FLAT
WASHER
(AFFIXED TO
BRACKETS)
PRELIMINARY ILLUSTRATION
68P09286A73 -1 4 -7
PRELIMINARY - UNDER DEVELOPMENT JUL 2007