User's Manual

AC P ower Cabling Installation Chapter 4: Access P oint Hardw are Installation
Procedure 4 -4 Procedure to Install AC P ower Cable
1
Ensure that AC power at the source is disabled before handling cable.
2
If not already done, route AC power cables through conduit to B CU Customer
Interface compartment.
3
In the B CU Customer Interface compartment, open the AC power cover , by
loosening two captive screws. AC P ower cover is hinged.
4
Loosen screws on AC power circuit breaker terminal block. Insert
AC power cables into LINE and NEUTRAL and tighten screws.
Ensure a good connection.
5
Close AC power cover and secure by tightening two captive screws.
Figure 4 -8 BCU AC P ower Connection
ti-cdma-04182.eps
Neutral Connectio
n
Line Connection
4 -24 68P09277A59 -5
Draft OCT 2006