User's Manual

Access P oint Hardw are Installation RF GPS Cabling Installation
Procedure 4 -7 Procedure for Installing RF GPS Antenna and Cabling (Continued)
3
The roof structure on which the mounting pole is attached should
be v eried b y a qualied structur al engineer for the weight of the
RF GPS engine and mounting hardw are or under adv erse conditions
for the installation area
Mounting the RF GPS antenna and hardware to an inadequate roof surface
and/or using inadequate installation methods can result in serious injury .
4
A ttach the RF GPS antenna assembly to the post mounting assembly and
secure the assembly to the assembly to the mounting kit using the screws
and nuts supplied. See Figure 4-15
5
A ttach the grounding kit to the mounting pole.
6
Connect one (1) N connector of the 50-feet superflex cable to the N jack of
the RF GPS antenna cable and route the other end of the cable down to the
B CU . If not already equipped with an SMA connector , attach an N-to-SMA
adapter . Make allowances for strain relief .
7
Route the cable to the underside of the B CU to
bulkhead connector (Customer Interface compartment).
If a lightning arrestor is in use, it will already be connected to the
RF GPS Module in the Customer Interface compartment
Continued
68P09277A59 -5 4 -35
Draft OCT 2006