User's Manual

Introduction Chapter 1: Introduction
Introduction
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Overview
This document provides information pertaining to the hardware and cabling installation for the
outdoor version of the Motorola Access P oint (AP) Hardware.
Manual Order
The manual order outlines the content make up starting with Chapter 1 and continuing through
Chapter X. A fter hardware installation has been completed, run the A TP for the system by
following the procedures defined in Chapter Y of this manual.
Chapter 1 Overview - This is a brief outline of the manual. It also provides a list of additional
documents and tools necessary to complete the procedures.
Chapter 2 Site Preparation - This chapter contains the information for site verification and
shipping and handling of the hardware.
Chapter 3 Cable Descriptions — This chapter contains general information on the cabling
available for the B CU and RF Head.
Chapter 4 Access P oint Hardware Installation — This chapter contains general information
and procedures for installing the Base Control Unit (B CU) and RF Head.
Chapter 5 Optional Equipment — This chapter contains general information and procedures
for installing optional equipment.
Chapter 6 Access P oint Hardware Operational check — This chapter contains general
information and operational checkout procedures for pre and post installation of the B CU
and RF Head.
Chapter 7 What’s Next - This chapter contains general information and procedures for site
clean up and installation checklist.
1 -2 68P09277A59 -5
Draft OCT 2006