User's Manual

Div ersit y Access P oint (DAP) RF Head Assembly Installation Chapter 4: Access P oint Hardw are Installation

Figure 4 -4 U -Bolt Sizing

ti-cdma-05727.eps

Table 4 -3 DAP U -Bolt Sizing

Pipe OD

Minimum Dimension B

Minimum Dimension C

(in) (mm) (in) (mm) (in) (mm)

2.067 52.50 3.886 98.70 0.6 15

2.469 62.71 4.429 112.50 0.6 15

3.068 77.93 5.098 129.50 0.6 15

Increasing dimension B beyond that indicated above will result in a corresponding increase

in dimension C in order to maintain proper clamping force

RF Head Assembly Installation Procedure

F ollow the steps in Procedure A -1 to install the RF Head Assembly including main Support

Bracket Assembly .

The following procedure is based on the RF Head arriving already assembled. If the

RF head must be assembled at the site then follow the procedure in Appendix A.

4 -16 68P09277A59 -5

Draft OCT 2006