User's Manual

Base Control Unit Installation Chapter 4: Access P oint Hardw are Installation
Procedure 4 -1 Procedure to Install Mounting Br ack et Assembly on a P ole (Continued)
7
Use the hammer to bend buckle tabs over strap.
Use electrical tape to cover over the buckle and straps.
8
P erform step 3 through step 8 , for the remaining straps.
9
Secure Mounting Bracket to P ole Mounting Bracket Assembly using 9 M6
bolts and washers (Refer to Figure 4-3 ). T orque bolts to 3.4 N–m (30 in–lbs).
10
Mounting bracket is ready for B CU attachement.
Installing the BCU
F ollow the steps in Procedure 4 -2 to install the Base Control Unit (B CU).
Procedure 4 -2 Procedure to Install the BCU
1
P erform the procedure for attaching the mounting bracket described in Procedure 4-1 .
2
Mount the B CU onto the mounting bracket and secure using 8 screws.
It is recommended that a minimum of two people attach the B CU on the pole
mounting bracket.
3
If not already open, open the B CU Customer Interface compartment. Route ground cable
to B CU and connect.
The cable access holes are covered. Remove the wing nuts and covers before routing
cables to and from the B CU Customer Interface Compartment.
4
Ensure the AC power is disabled at the source before attempting to install the AC power cabling.
F or AC power cable perform Procedure 4-4 .
5
F or RF Head DC power cable installation, perform Procedure 4-5 .
6
F or Antenna cable installation, perform .
7
F or fiber optic cable installation, perform
8
F or RF GPS cable installation, perform Procedure 4-7
F or RGPS cable installation, perform Procedure 4-6 .
Continued
4 -12 68P09277A59 -5
Draft OCT 2006