Installation Instructions

R20 1X UBS Macro B T S Hardw are Installation Adding an Optional RX Splitter

Adding an Optional RX Splitter

■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■

■

Objective

The objective of this section is to mount the optional RX splitter onto the bottom of the XMI shelf .

Cabling of the RX splitter to the XMIs will be performed after all of the additional

expansion equipment (i.e., XMI, DMI, circuit breaker/output power connector

assemblies, etc.) is installed in the frame.

Required items

Parts

The following part is required:

• W ide band (800 MHz through 2.1 GHz RF bands) single band RX splitter (Motorola

model STRG4029)

Tools

The following tools are required:

• TORX T25 bit and driver

• T orque driver

Procedure

Procedure 3 -5 contains the steps for adding the RX splitter to the bottom of the XMI shelf .

Procedure 3 -5 Adding an RX splitter to the XMI shelf

Remove the RX splitter from its packaging and inspect it for damage.

Continued

68P09283A62 -2 3 -17

PRELIMINARY A UG 2007