User's Manual

Test Equipment Set-up – continued

FEB 2005 1X SC 4812T Lite BTS Optimization/ATP 3-79

PRELIMINARY

IS–95A/B Operation

Optimization and ATP Testing for IS–95A/B Sites and Carriers may be

performed using the following Test Equipment:

S CyberTest

S Advantest R3267 Spectrum Analyzer with R3562 Signal Generator

S Advantest R3465 Spectrum Analyzer with R3561L Signal Generator

and HP–437B or Gigatronics Power Meter

S Agilent E4406A Transmitter Test Set with E4432B Signal Generator

S Agilent 8935 Series E6380A Communications Test Set (formerly HP

8935)

S Hewlett–Packard HP 8921 (with CDMA Interface and, for 1.9 GHz,

PCS Interface) and HP–437B or Gigatronics Power Meter

S Spectrum Analyzer (HP8594E) – optional

S Rubidium Standard Timebase – optional

CDMA2000 1X Operation

Optimization and ATP Testing for CDMA2000 1X Sites and Carriers

may be performed using the following Test Equipment:

S Advantest R3267 Spectrum Analyzer with R3562 Signal Generator

S Agilent E4406A Transmitter Test Set with E4432B Signal Generator

S Agilent 8935 Series E6380A Communications Test Set (formerly HP

8935) with Option 200 or R2K and with E4432B Signal Generator for

1X FER

S Agilent E7495A Communications Test Set

Test Equipment Preparation

See Appendix F for specific steps to prepare each type of Test Set and

Power Meter to perform Calibration and ATP.

Agilent E7495A Communications Test Set requires additional set–up

and preparation. This is described in detail in Appendix F.

Test Equipment Connection

Charts

To use the following charts to identify necessary Test Equipment

Connections, locate the Communications System Analyzer being used in

the COMMUNICATIONS SYSTEM ANALYZER Columns, and read

down the column. Where a dot appears in the column, connect one end

of the Test Cable to that Connector. Follow the horizontal line to locate

the end connection(s), reading up the column to identify the appropriate

Test Equipment and/or BTS Connector.