User's Manual

CSM System Time – GPS and HSO Verification – continued

FEB 2005 1X SC 4812T Lite BTS Optimization/ATP 3-51

PRELIMINARY

Test Equipment Set–up (GPS

and HSO Verification)

Perform the procedure in Table 3-23 to set–up Test Equipment.

Table 3-23: Test Equipment Set–up (GPS and HSO Verification) Procedure

Step Action

1 Perform one of the following as required by installed equipment:

1a For Local GPS (RF–GPS): Verify that a CSM Card with a GPS Receiver is installed in the Primary

CSM Slot, CSM 1, and that the card is INS_ACTIVE (bright green).

– Verify by checking the Card Ejector Tabs for Kit Number SGLN1145 on the card in the CSM 1

Slot.

1b For Remote GPS (RGPS): Verify that a CSM–II Card is installed in Primary Slot CSM 1 and that the

card is INS_ACTIVE (bright green).

– Verify by checking the Card Ejector Tabs for Kit Number SGLN4132ED or subsequent.

2 Remove CSM 2 (if installed) and connect a Serial Cable from the LMF COM 1 Port (via Null Modem

Card) to the MMI Port on CSM 1.

– Refer to Figure 3-11.

3 Reinstall CSM 2.

4 Start an MMI Communication Session with CSM 1 by using the Windows Desktop Shortcut Icon.

– Refer to Table 3-14 .

5 When the Terminal Screen appears press the Enter Key until the CSM> Prompt appears.

In the Power Entry Compartment, connect the GPS

Antenna to the RF GPS Connector ONLY.

Damage to the GPS Antenna and/or receiver can result if

the GPS Antenna is inadvertently connected to any other

RF Connector.

CAUTION