User's Manual

Download the BTS – continued
FEB 2005 1X SC 4812T Lite BTS Optimization/ATP 3-41
PRELIMINARY
Verify GLI ROM Code Loads
Devices should not be loaded with a RAM Code Version that is not
compatible with the ROM Code with which they are loaded. Before
downloading RAM Code and Data to the Processor Cards, perform the
procedure in Table 3-16 to verify that the GLI Devices are loaded with
the correct ROM Code for the Software Release used by the BSS.
Prerequisite
Identify the correct GLI ROM Code load for the Software Release being
used on the BSS by referring to the Version Matrix section of the SCt
CDMA Release Notes (supplied on the tapes or CD–ROMs containing
the BSS Software).
Table 3-16: Verify GLI ROM Code Loads Procedure
n Step Action
1 If it has not already been done, start a GUI LMF Session and log into the BTS.
– Refer to Table 3-10.
2 Select all GLI Devices by clicking on them, and select Device > Status from the BTS Menu Bar.
3 In the Status Report Window that opens, note the number in the ROM Ver Column for each
GLI2.
4 If the ROM Code loaded in the GLI Cards is not the correct one for the Software Release being
used on the BSS, perform the following actions.
4a Log out of the BTS as described in Table 3-12 or Table 3-13, as applicable.
4b Disconnect the LMF Computer.
4c Reconnect the Span Lines as described in Table 5-4.
4d Have the CBSC download the correct ROM Code Version to the BTS Devices.
5 When the GLI Cards have the correct ROM Load for the Software Release being used, perform
the following actions.
5a Ensure that the Span Lines are disabled as outlined in Table 3-5.
5b Proceed to downloading RAM Code and Data.
3