User's Manual

Using the LMF – continued

3-34 1X SC 4812T Lite BTS Optimization/ATP FEB 2005

PRELIMINARY

Logging Out of a BTS from the CLI Environment

Perform the procedure in Table 3-13 to logout of a BTS when using the

CLI Environment.

Table 3-13: BTS CLI Logout Procedure

n Step Action

NOTE

If the BTS is also logged into from a GUI running at the same time and further work must be done

with it in the GUI, proceed to Step 1.

1 Log out of a BTS by entering the following command:

logout bts–<bts#>

– A system response similar to the following will be displayed:

LMF>

13:24:51.028 Command Received and Accepted

COMMAND=logout bts–33

13:24:51.028 Command In Progress

13:24:52.04 Command Successfully Completed

REASON_CODE=”No Reason”

2 If desired, close the CLI Interface by entering the following command:

exit

– A response similar to the following will be displayed before the window closes:

Killing background processes....

Establishing an MMI

Communication Session

Equipment Connection

Figure 3-9 illustrates common equipment connections for the LMF

Computer. For specific connection locations on FRUs, refer to the

illustration accompanying the procedures that require the MMI

Communication Session..

Initiate MMI Communication

For those procedures that require MMI Communication between the

LMF and BTS FRUs, perform the procedures in Table 3-14 to initiate

the Communication Session..

Table 3-14: Establishing MMI Communication Procedure

n Step Action

1 Connect the LMF Computer to the equipment as detailed in the applicable procedure that requires

the MMI Communication Session.

table continued on next page