User's Manual
RFDS Set–up and Calibration – continued
3-136 1X SC 4812T Lite BTS Optimization/ATP FEB 2005
PRELIMINARY
Set RFDS Configuration Data
If an RFDS is installed, the RFDS Configuration Data must be manually
entered.
Prerequisite
S LMF is logged into the BTS
The entered antenna# index numbers must correspond to
the antenna# index numbers used in the Antenna Maps.
NOTE
Perform the procedure in Table 3-49 to set RFDS Configuration Data.
Table 3-49: Set RFDS Configuration Data Procedure
n Step Action
1 Click on Util in the BTS Menu Bar, and select Edit > RFDS Configuration... from the
Pull–down Menus.
–A Tabbed Data Entry Pop–up Window will appear.
2 In the Data Entry Pop–up Window, click on the TX RFDS Configuration or RX RFDS
Configuration Tab, as required.
3 To add a new Antenna Number, perform the following actions.
3a Click on the Add Row Button.
3b Click in the Antenna #, Cal Antenna, Scap Antenna, or Populate [Y/N] Columns, as required.
3c Enter the desired data.
4 To edit existing values click in the Data Box to be changed and change the value.
NOTE
Refer to the CDMA Help > Utility Menu > Edit–RFDS Configuration... section of LMF Help
function on–line documentation for RFDS Configuration Data examples.
5 To delete a row, click on the row and then click on the Delete Row Button.
6 For each tab that needs to be changed, click on the Save Button to save the displayed values.
7 Click on the Dismiss Button to close the window.
NOTE
S Values entered or changed after the Save Button was used will be lost when the window is
dismissed.
– Entered values will be used by the LMF as soon as they are saved.
S It is not necessary to log out and log back into the LMF for changes to take effect.
3