User's Manual

RFDS Set–up and Calibration – continued

FEB 2005 1X SC 4812T Lite BTS Optimization/ATP 3-135

PRELIMINARY

Set Antenna Map Data

The Antenna Map Data must be entered manually if an RFDS is

installed. Antenna Map Data does not need to be entered if an RFDS is

not installed. The Antenna Map Data is only used for RFDS Tests and is

required if an RFDS is installed.

Prerequisite

S The LMF is logged into the BTS.

Perform the procedure in Table 3-48 to set Antenna Map Data for the

RFDS.

Table 3-48: Set Antenna Map Data Procedure

n Step Action

1 Click on Util in the BTS Menu Bar, and select Edit > Antenna Map... from the Pull–down Menu.

– A tabbed Data Entry Pop–up Window will appear.

2 In the Data Entry Pop–up Window, click on the TX Antenna Map or RX Antenna Map Tab to

select the Antenna Map to be edited.

3 Locate the Carrier and Sector Number for which data is to be entered or edited, and click in the

column where entry or editing is needed.

4 Enter/edit Antenna # and Antenna Label column data as needed for each carrier.

NOTE

Refer to the CDMA Help > Utility Menu > Edit–Antenna Map... section of LMF Help function

on–line documentation for Antenna Map examples.

5 For each Tab that needs to be changed, click on the Save Button to save displayed values.

6 Click on the Dismiss Button to close the window.

NOTE

S Values entered or changed after the Save Button was used will be lost when the window is

dismissed.

– Entered values will be used by the LMF as soon as they are saved.

S It is not necessary to log out and log back into the LMF for changes to take effect.