User's Manual
RFDS Set–up and Calibration – continued
3-130 1X SC 4812T Lite BTS Optimization/ATP FEB 2005
PRELIMINARY
Checking and Setting RFDS
Parameters
Perform the procedure in Table 3-45 to review and/or edit RFDS
Parameters.
Table 3-45: RFDS Parameter Settings Procedure
n Step Action
NOTE
Log out of the BTS prior to perform this procedure.
1 Using a Text Editor, verify that the following fields are set correctly in the bts–#.cdf File.
EXAMPLE:
Asu1Equip = 1
Asu2Equip = 0 (1 if system is non-duplexed)
Mc1Equip = 0
Mc2Equip = 0
Mc3Equip = 0
Mc4Equip = 0
RfdsEquip = 2
TestOrigDN = ’123456789’
TsuEquip = 1
NOTE
The above is an example of entries extracted from the bts–#.cdf File that should have been
generated by the OMC–R and copied to the LMF.
– These fields will have been set by the OMC–R if the RFDSPARM Database is modified for
the RFDS.
2 Save changes and/or quit the editor.
3 Log into the BTS using an LMF GUI Session.
– Refer to Table 3-10.
4 Determine if changes were made to the bts–#.cdf File Fields listed in Step 1.
S If changes were not made, proceed to Step 7.
S If changes were made, proceed to Step 5.
NOTE
To make certain the complete data download is accepted, the MGLI should be OOS_RAM
(yellow) when RFDS Parameter Settings are downloaded.
5 When changes are made to RFDS Parameters in the bts–#.CDF File, data must be downloaded to
the MGLI by performing the following actions
5a To be sure it does not take control when the MGLI is disabled, manually disable the Redundant
GLI Card by unseating it from the Backplane Connectors and sliding it partially out of the SCCP
Cage Slot.
5b Click on the MGLI.
table continued on next page
3