User's Manual

Entering or Changing Router FE Interface IP Address – continued
FEB 2005 1X SC 4812T Lite BTS Optimization/ATP I-89
PRELIMINARY
Table I-17: Enter/Change BTS Router FE Interface IP Addresses and Operating Parameters
n ActionStep
8 At the Global Configure Mode Prompt, enter the following command to access the Configure
Interface Submode for the interface requiring IP Address assignment/change:
int
erface fastethernetinterface#
– Where interface# = 0/0 or 0/1, as applicable.
– A response similar to the following will be displayed:
BTSRTR–bts#–1–1(config)# int fa0/1
BTSRTR–
bts#–1–1(config–if)#
9 At the Configure Interface Submode Prompt, assign or change the interface IP Address by
entering the following command.
ip address IP_addr Subnet_mask
– Where:
IP_addr = the required IP Address for the interface; for example, 192.168.147.1
Subnet_mask = the required Subnet Mask for the interface; for example, 255.255.255.0
– A response similar to the following will be displayed:
BTSRTR–bts#–1–1(config–if)# ip address 192.168.147.1 255.255.255.0
BTSRTR–
bts#–1–1(config–if)#
10 To complete configuration of the interface, enter the following Parameter Settings, one at a time,
pressing Enter after each:
duplex full
speed 100
keepalive 1
no shutdown
11 Return to the Global Configuration Mode by entering the exit Command.
– A response similar to the following will be displayed:
BTSRTR–bts#–1–1(config–if)# exit
BTSRTR–
bts#–1–1(config)#
12 If the IP Address and/or Parameters for the other FE Interface on the BTS Router need to be
assigned or changed at this time, repeat Step 8 through Step 11 for the other FE Interface.
table continued on next page
I