User's Manual

Verifying IOS Canned Version of the CF Memory Card – continued
FEB 2005 1X SC 4812T Lite BTS Optimization/ATP I-31
PRELIMINARY
Table I-7: Transfer Canned Configuration Files to the BTS Router Using a TFTP Server
n ActionStep
18 When prompted for the Destination File Name, press the Enter Key.
– A response similar to the following will be displayed:
BTSRTR1#copy canned–config start
Destination filename [startup–config]?
2457 bytes copied in 3.52 secs
BTSRTR1#
19 Display and note the file size of the startup–config File by entering the following command.
dir nvram:
– A response similar to the following will be displayed:
Directory of nvram:/
26 –rw– 2457 <no date> startup–config
27 –––– 5 <no date> private–config
29688 bytes total (24774 bytes free)
BTSRTR1#
20 Scroll the HyperTerminal Window back to the slot0: Directory Display obtained in Step 16,
above.
21 Compare the file size of the startup–config File to the Canned Configuration File to verify the
Copy Operation.
– The file sizes should be the same.
22
If desired, the contents of the startup–config File may be verified against the file listings at
the end of this appendix for the blue or red Canned Configuration, as applicable, by entering the
following command.
sh
ow startup–config
NOTE
Pressing the Space Bar at the MORE prompt will scroll another full screen of data.
Pressing the Enter Key will scroll the screen one line at a time.
23 Verify that the BTS Router will boot properly on the IOS and revised Start–up
Configuration Files by entering the following command.
reload
– A response similar to the following will be displayed:
BTSRTR1#reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload? [confirm]
24 If prompted to save a modified configuration, enter n for “no,” and press the Enter Key.
25 When prompted to proceed with Reload, press the Enter Key to continue the Reload Operation.
table continued on next page
I