User's Manual

Terminal Setup – continued
I-6 1X SC 4812T Lite BTS Optimization/ATP FEB 2005
PRELIMINARY
Adapter
DB–9 Receptacle
Socket Numbering
(Mating Side)
Adapter
8–contact Receptacle
Contact Numbering
(Mating Side)
12345
6789
12345678
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
NC
NC
DB–9
Receptacle
8–contact
Modular
Receptacle
Figure I-2: Wiring Diagram, DB–9 Plug–to–8–Contact Modular Plug Adapter
Table I-2: Establishing BTS Router Serial Communication
n Step Action
1 If it has not been done, start the computer and allow it to complete the Boot Process.
2 If a named HyperTerminal Connection for BTS Router Serial Communication or BTS
Card/Module MMI Communication has not been created on the LMF Computer, create one as
described in Table I-1 in the “Terminal Set–up” section of this appendix.
3 Connect the computer to the BTS Router as shown in Figure I-3.
4
Start the named HyperTerminal Connection for BTS Router Communication Sessions by double
clicking on its Windows Desktop Shortcut.
NOTE
If a Windows Desktop Shortcut was not created for the Communication Session, access the
connection from the Windows Start Menu by selecting:
Programs > Accessories > Hyperterminal > HyperTerminal > <Named HyperTerminal
Connection (for example, BTSRTR)>
5 Once the connection window opens, establish communication with the BTS Router by pressing
the computer Enter Key until the prompt identified in the applicable procedure is obtained.
I