User's Manual

Terminal Setup – continued
FEB 2005 1X SC 4812T Lite BTS Optimization/ATP I-3
PRELIMINARY
Table I-1: Establish HyperTerminal Connection
n ActionStep
3 When the Connection Description Box opens, perform the following actions.
3a Type a name for the connection being defined (for example, BTSRTR Session, MMI) in the
Name: Window.
3b Highlight any icon preferred for the named connection in the Icon: Chooser Window.
3c Click OK.
4 From the Connect using: Pick List in the Connect To Box displayed, perform the following
actions.
4a Select the RS–232 Port to be used for the connection (e.g., COM1 or COM2 – Win2000 or Direct
to Com 1 or Direct to Com 2 – Win98).
4b Click OK.
5 In the Port Settings Tab of the COM# Properties Window displayed, configure the RS–232 Port
Settings as follows:
S Bits per Second: 9600
S Data Bits: 8
S Parity: None
S Stop Bits: 1
S Flow Control: None
6 Click OK.
7 With the HyperTerminal Window still open and the connection running, select:
File > Properties
8 Click the Settings Tab, click the arrow in the Emulation Window, and select VT100 from the
Pull–down Menu.
9 Click the ASCII Set–up Button, uncheck all boxes in the ASCII Set–up Window that appears,
and click OK.
10 Click OK for the Connection Properties Box.
11 Save the defined connection by selecting:
File > Save
12 Close the HyperTerminal Window by selecting:
File > Exit
13 Click the Yes Button to disconnect when prompted.
table continued on next page
I