User's Manual

Abbreviated (All–inclusive) Acceptance Tests – continued
4-10 1X SC 4812T Lite BTS Optimization/ATP FEB 2005
PRELIMINARY
Table 4-4: All RX Acceptance Test Procedure
n ActionStep
5 Verify that the correct Channel Number for the selected carrier is shown in the Carrier #
Channels Box.
– If it is not, obtain the latest bts–#.cdf (or bts–#.necf) and cbsc–#.CDF Files from the CBSC.
NOTE
If necessary, the correct Channel Number may be manually entered into the Carrier # Channels
Box.
6 Select the appropriate RX Branch (BOTH, MAIN, or DIVersity) in the Pull–down Menu.
7 In the Rate Set Box, select the appropriate Data Rate (1=9600, 2=14400, 3=9600 1X) from the
Pull–down Menu.
NOTE
The Rate Set Selection of 1 is only available if non–1X Cards are selected for the test.
The Rate Set Selection of 3 is only available if 1X Cards are selected for the test.
8 Enter the Channel Elements to be tested for the RX ATP in the Channel Element(s) Box.
– By default, all Channel Elements are specified.
– The Channel Element Numbers are 0.based; that is the first Channel Element is 0.
NOTE
Use one of the following methods to enter more than one Channel Element:
– Enter non–sequential Channel Elements separated by a comma and no spaces (for example;
0,5,15).
– Enter a range of sequential Channel Elements by typing the first and last Channel Elements
separated by two periods (for example; 0..15).
9 Click OK to display a Status Bar followed by a Directions Pop–up Window.
10 Follow Cable Connection Directions as they are displayed, and click the Continue Button to
begin testing.
– When the ATP Process is completed, results will be displayed in the Status Report Window.
11 Click either the Save Results Button or the Dismiss Button.
* IMPORTANT
If Dismiss is used, the test results will not be saved in the Test Report File.
4