User's Manual

Abbreviated (All–inclusive) Acceptance Tests – continued
FEB 2005 1X SC 4812T Lite BTS Optimization/ATP 4-9
PRELIMINARY
Table 4-3: All TX Acceptance Test Procedure
n ActionStep
6 In the Rate Set Box, select the appropriate Transfer Rate (1 = 9600, 3 = 9600 1X) from the
Pull–down Menu.
NOTE
The Rate Set Selection of 3 is only available if 1X Cards are selected for the test.
7 In the Test Pattern Box, select the Test Pattern to use for the Acceptance Test from the Pull–down
Menu.
– Refer to “Test Pattern Drop–down Pick List” under “TX Calibration and the LMF” in the Bay
Level Offset Calibration section of Chapter 3.
8 Click OK to display a Status Bar followed by a Directions Pop–up Window.
9 Execute the Cable Connection Directions as they are displayed, and click the Continue Button to
begin testing.
– As the ATP Process is completed, results will be displayed in the Status Report Window.
10 Click either the Save Results Button or the Dismiss Button.
* IMPORTANT
If Dismiss is used, the test results will not be saved in the Test Report File.
All RX ATP Test
Perform the procedure in Table 4-4 to perform the Abbreviated,
All–inclusive Receive Test.
Table 4-4: All RX Acceptance Test Procedure
n Step Action
1 Set–up the Test Equipment for Abbreviated Tests per Table 4-1.
NOTE
If the LMF has been logged into the BTS with a different Multi–Channel Preselector setting than
the one to be used for this test, the LMF must be logged out of the BTS and logged in again with
the new Multi–Channel Preselector setting.
– Using the wrong MPC Setting can cause a false test failure.
2 Select the BBX Cards and MCC Cards to be tested.
3 Click on Tests in the BTS Menu Bar, and select All RX ATP... from the Pull–down Menu.
4 Select the appropriate carrier(s) and sector(s) (carrier-bts#-sector#-carrier#) from those displayed
in the Channels/Carrier Pick List.
NOTE
To select multiple items, hold down the Shift or Ctrl Key while clicking on Pick List Items to
select multiple carrier(s)–sector(s).
table continued on next page
4