User's Manual

Abbreviated (All–inclusive) Acceptance Tests – continued
4-8 1X SC 4812T Lite BTS Optimization/ATP FEB 2005
PRELIMINARY
Table 4-2: All TX/RX Acceptance Test Procedure
n ActionStep
9 In the Test Pattern Box, select the Test Pattern to use for the Acceptance Tests from the
Pull–down Menu.
– Refer to “Test Pattern Drop–down Pick List” under “TX Calibration and the LMF” in the Bay
Level Offset Calibration section of Chapter 3.
10 Click OK to display a Status Bar followed by a Directions Pop–up Window.
11 Execute the Cable Connection Directions as they are displayed, and click the Continue Button to
begin testing.
– As the ATP Process is completed, results will be displayed in the Status Report Window.
12 Click either the Save Results Button or the Dismiss Button.
* IMPORTANT
If Dismiss is used, the test results will not be saved in the Test Report File.
All TX ATP Test
Perform the procedures in Table 4-3 to perform the Abbreviated,
All–inclusive Transmit Test.
Table 4-3: All TX Acceptance Test Procedure
n Step Action
1 Set–up the Test Equipment for Abbreviated Tests per Table 4-1.
2 Select the BBX Cards and MCC Cards to be tested.
3 Click on Tests in the BTS Menu Bar, and select All TX ATP... from the Pull–down Menu.
4 Select the appropriate carrier(s) and sector(s) (carrier-bts#-sector#-carrier#) from those displayed
in the Channels/Carrier Pick List.
NOTE
To select multiple items, hold down the Shift or Ctrl Key while clicking on Pick List Items to
select multiple carrier(s)–sector(s).
5 Verify that the correct Channel Number for the selected carrier is shown in the Carrier #
Channels Box.
– If it is not, obtain the latest bts–#.cdf (or bts–#.necf) and cbsc–#.CDF Files from the CBSC.
NOTE
If necessary, the correct Channel Number may be manually entered into the Carrier # Channels
Box.
table continued on next page
4