User's Manual

Preparing the LMF – continued
FEB 2005 1X SC 4812T Lite BTS Optimization/ATP 3-11
PRELIMINARY
Copy BTS and CBSC CDF (or
NECF) Files to the LMF
Computer
Before logging on to a BTS with the LMF Computer to execute
Optimization/Acceptance Test Procedures, the correct bts-#.cdf and
cbsc-#.cdf (or bts–#.necf and cbsc–#.necf) Files must be obtained from
the CBSC and put in a bts-# folder in the LMF Computer. This requires
creating versions of the CBSC CDF Files on a DOS–formatted Floppy
Diskette and using the diskette to install the CDF Files on the LMF
Computer.
– If the LMF has FTP Capability, the FTP method can be used to
copy the CDF or NECF Files from the CBSC.
– On Sun OS workstations, the UNIX2DOS command can be used in
place of the CP Command (e.g., unix2dos bts–248.cdf
bts–248.cdf). This should be done using a copy of the CBSC
CDF File so the original CBSC CDF File is not changed to DOS
Format.
When copying CDF and NECF Files, comply with the
following conventions to prevent BTS Login problems
with the Windows LMF:
S The numbers used in the bts-#.cdf and cbsc-#.cdf (or
bts–#.necf and cbsc–#.necf) file names must
correspond to the locally-assigned numbers for each
BTS and its controlling CBSC.
S The generic cbsc–1.cdf (or cbsc–#.necf) file supplied
with the Windows LMF will work with locally
numbered BTS CDF Files. Using this file will not
provide a valid Optimization unless the generic file is
edited to replace default parameters (e.g., Channel
Numbers) with the operational parameters used locally.
NOTE
The procedure in Table 3-3 lists the steps required to transfer the CDF
Files from the CBSC to the LMF Computer. For further information,
refer to the LMF On–Line Help.
Table 3-3: Copy CDF or NECF Files to the LMF Computer Procedure
n Step Action
AT THE CBSC:
1 Login to the CBSC Workstation.
2 Insert a DOS–formatted Floppy Diskette in the Workstation Floppy Drive.
3 Type eject –q and press the Enter Key.
table continued on next page
3