User's Manual

Required Test Equipment and Software – continued
1-6 1X SC 4812T Lite BTS Optimization/ATP FEB 2005
PRELIMINARY
Equipment Warm–up
After arriving at a site, Test Equipment should be plugged in and turned
on immediately to provide the longest possible time for warm–up and
sTabilization. The following pieces of Test Equipment must be
warmed–up for a minimum of 60 minutes prior to use for BTS
Optimization or RFDS Calibration:
S Communications Test Set
S Rubidium Time Base
S Power Meter
LMF Computer and Software
LMF Hardware Requirements
An LMF Computer Platform that meets the following requirements (or
better) is recommended:
S Notebook Computer
S 266 MHz (32 bit CPU) Pentium Processor, or better
S MSr Windows 98R Second Edition (SE) or later WindowsE
Operating System
S 4GB Internal Hard Disk Drive
S SVGA 12.1–inch Active Matrix Color Display with 1024 x 768
(recommended) or 800 x 600 Pixel Resolution and capability to
display more than 265 colors.
If 800 x 600 Pixel Resolution is used, the LMF Window
must be maximized after it is displayed.
NOTE
S Memory Requirements:
– Minimum required RAM: 96MB
– Recommended RAM:
• 128MB for Windows 98 SE
• 256MB for Windows 2000 or later
S 20X CD–ROM Drive
S 3 1/2 inch Floppy Drive
S 56Kbps V.90 Modem
S Serial Port (COM 1)
S Parallel Port (LPT 1)
S PCMCIA Ethernet Interface Card (for example, 3COM Etherlink III)
with a 10BaseT–to–COAX Adapter
1