User's Manual

List of Tables – continued
xii 1X SC 4812T Lite BTS Optimization/ATP FEB 2005
PRELIMINARY
Table 6-10: Device Enable (INS) Failure Troubleshooting Procedure 6-10 . . . . . . . .
Table 6-11: LPA Errors 6-11 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-12: BLO Calibration Failure Troubleshooting Procedure 6-12 . . . . . . . . . . .
Table 6-13: Calibration Audit Failure Troubleshooting Procedure 6-13 . . . . . . . . . .
Table 6-14: All Tests Fail Troubleshooting Procedure 6-14 . . . . . . . . . . . . . . . . . . . .
Table 6-15: Forward Link Failure (BTS Passed Reduced ATP)
Troubleshooting Procedure 6-18 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-16: TX Mask Measurement Failure Troubleshooting Procedure 6-18 . . . . .
Table 6-17: Rho and Pilot Time Offset Measurement Failure
Troubleshooting Procedure 6-18 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-18: Code Domain Power and Noise Floor Measurement Failure
Troubleshooting Procedure 6-19 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-19: Multi-FER Failure Troubleshooting Procedure 6-20 . . . . . . . . . . . . . . . .
Table 6-20: CSM Reference (Clock) Sources by GPS Type and Kit Number 6-22 . .
Table 6-21: No GLI Control Through LMF (All GLI Cards) 6-25 . . . . . . . . . . . . . .
Table 6-22: No GLI Control Through Span Line Connection (Both GLI Cards) 6-25
Table 6-23: MGLI Control Good – No Control Over Co–located GLI 6-25 . . . . . . .
Table 6-24: MGLI Control Good – No Control Over AMR 6-26 . . . . . . . . . . . . . . .
Table 6-25: MGLI Control Good – No Control over Co–located BBX Cards 6-26 .
Table 6-26: BBX Control Good – No (or Missing) Span Line Traffic 6-26 . . . . . . . .
Table 6-27: No MCC–1X/MCC24E/MCC8E Channel Elements 6-26 . . . . . . . . . . .
Table 6-28: No DC Input Voltage to Power Supply Module
Troubleshooting Procedure 6-27 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-29: No DC Input Voltage to any SCCP Cage Module
Troubleshooting Procedure 6-28 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-30: TX and RX Signal Routing Problems Troubleshooting Procedure 6-28
Table 6-31: RFDS Fault Isolation – All Tests Fail Troubleshooting Procedure 6-29
Table 6-32: RFDS Fault Isolation – All Tests Fail on Single Antenna Path
Troubleshooting Procedure 6-30 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-33: Card/Module PWR/ALM LED States 6-31 . . . . . . . . . . . . . . . . . . . . . . .
Table 6-34: Card/Module PWR/ALM LED States 6-31 . . . . . . . . . . . . . . . . . . . . . . .
Table 6-35: CSM Card PWR/ALM LED States 6-32 . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-36: GLI Card ACTIVE LED States 6-34 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-37: GLI Card MASTER LED States 6-35 . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-38: GLI Card ALARM LED States 6-35 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-39: GLI Card STATUS LED States 6-35 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-40: GLI Card STATUS LED States 6-35 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-41: BBX Card PWR/ALM LED States 6-37 . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6-42: BBX Card ACTIVE LED States 6-38 . . . . . . . . . . . . . . . . . . . . . . . . . . .