User's Manual

Preparing the LMF – continued

08/01/2001

3-11

1X SCt4812ET Lite BTS Optimization/ATP

PRELIMINARY

cbsc File

The cbsc–#.cdf (Centralized Base Station Controller) file contains data

for the BTS. If one is not obtained from the CBSC, a copy of the default

cbsc–1.cdf file located in the cdma folder can be used.

Using the generic cbsc–1.cdf file will not provide a valid

optimization unless the generic file is edited to replace

default parameters with local operational parameters (e.g.,

CDMA channel numbers must be changed from the default

“384” to those used locally by the BTS).

IMPORTANT

loads Folder

The loads folder contains the version folder(s). It does not contain any

files.

version Folder

The version folder(s) contains the code and data folders. It does not

contain any files. The name of version folders is the software version

number of the code files that are included in its code folder. Version

folders are created as part of the CDMA LMF installation and CDMA

LMF updates. Each time the CDMA LMF is updated, another version

folder will be created with the number of the software version for the

code files being installed.

code Folder

The code folder contains the binary files used to load code into the

devices. A unique binary code file is required for each device type in the

BTS to be supported with the CDMA LMF. Current version code files

for each supported device created in this folder from the CDMA LMF

CD ROM as part of the CDMA LMF installation/update process.

Figure 3-5 shows an example of the file naming syntax for a code load

file.