User's Manual

Test Equipment Preparation – continued
PRELIMINARY
1X SCt4812ET Lite BTS Optimization/ATP
08/01/2001
F-6
Setting HP8921A and
HP83236A/B GPIB Address
Table F-4: Setting HP8921A GPIB Address
Step Action
1 If you have not already done so, turn the HP8921A power on.
2 Verify that the GPIB addresses are set correctly.
S HP8921A HP–IB Adrs = 18, accessed by pushing LOCAL and selecting More and I/O Configure
on the HP8921A/600. (Consult test equipment OEM documentation for additional info as required).
S HP83236A (or B) PCS Interface GPIB address=19. Set dip switches as follows:
– A1=1, A2=1, A3=0, A4=0, A5=1, HP–IB/Ser = 1
Pretest Setup for HP8921A
Before the HP8921A CDMA analyzer is used for LMF controlled testing
it must be set up correctly for automatic testing.
Table F-5: Pretest Setup for HP8921A
Step Action
1 Unplug the memory card if it is plugged in.
2 Press the CURSOR CONTROL knob.
3 Position the cursor at IO CONFIG (under To Screen and More) and select it.
4 Select Mode and set for Talk&Lstn.
Pretest Setup for HP8935
Before the HP8935 CDMA analyzer is used for LMF controlled testing
it must be set up correctly for automatic testing.
Table F-6: Pretest Setup for HP8935
Step Action
1 Unplug the memory card if it is plugged in.
2 Press the Shift button and then press the I/O Config button.
3 Press the Push to Select knob.
4 Position the cursor at IO CONFIG and select it.
5 Select Mode and set for Talk&Lstn.
F