User's Manual

Acceptance Tests – Test Set Up

08/01/2001

4-3

68P09253A60

1X SCt4812ET Lite BTS Optimization/ATP

PRELIMINARY

Required Test Equipment

The following test equipment is required:

S LMF

S Power meter (used with HP8921A/600 and Advantest R3465)

S Communications test set

Before installing any test equipment directly to any TX

OUT connector, verify that there are no CDMA channels

keyed.

At active sites, have the OMCR/CBSC place the carrier

assigned to the LPAs under test OOS. Failure to do so can

result in serious personal injury and/or equipment damage.

WARNING

You must recalibrate the test equipment before using it to

perform the TX Acceptance Tests.

NOTE

Acceptance Test Equipment

Set Up

Follow the steps in Table 4-1 to set up test equipment for all tests.

Table 4-1: Set Up Test Equipment – TX Output Verify/Control Tests

Step Action

1 If it has not already been done, interface the LMF computer to the BTS (refer to Table 3-6 and

Figure 3-10).

2 If it has not already been done, refer to Table 3-7 to start a GUI LMF session and log into the BTS.

3 If it has not already been done, refer to Figure 3-17 or Figure 3-18, as applicable for the test

equipment being used, to connect test equipment for acceptance testing.

* IMPORTANT

CDMA LMF–based measurement commands factor in TX test cable loss between the RFM frame and

test equipment. No additional attenuation can be inserted as the additional losses would not be

factored in.