User's Manual

Using CDMA LMF – continued

PRELIMINARY

1X SCt4812ET Lite BTS Optimization/ATP

08/01/2001

3-24

BTS Login from the CLI Environment

Follow the procedures in Table 3-8 to log into a BTS when using the

CLI environment.

If the CLI and GUI environments are to be used at the

same time, the GUI must be started first and BTS login

must be performed from the GUI. Refer to Table 3-7 to

start the GUI environment and log into a BTS.

IMPORTANT

Table 3-8: BTS CLI Login Procedure

n Step Action

1 Double–click the WinLMF CLI desktop icon (if the LMF CLI environment is not already

running).

NOTE

If a BTS was logged into under a GUI session before the CLI environment was started, the CLI

session will be logged into the same BTS, and step 2 is not required.

2 At the /wlmf prompt, enter the following command:

where:

host = MGLI card IP address (defaults to address last logged into for this BTS or 128.0.0.2 if this

is first login to this BTS)

port = IP port of the BTS (defaults to port last logged into for this BTS or 9216 if this is first login

to this BTS)

A response similar to the following will be displayed:

LMF>

13:08:18.882 Command Received and Accepted

COMMAND=login bts–33

13:08:18.882 Command In Progress

13:08:21.275 Command Successfully Completed

REASON_CODE=”No Reason”

Logging Out

Logging out of a BTS is accomplished differently for the GUI and CLI

operating environments.