User Manual
Download Files to the LMF - Site Specific BTS Files
68P09255A57-2
Aug 2002
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
PRELIMINARY
3-22
Download Files to the LMF - Site Specific BTS Files
These procedures must be followed prior to an initial BTS optimization,
or anytime a new release of the BTS operating system software is to be
loaded from the LMF to the BTS.
Follow the steps outlined in Table 3-9 to create a bts directory and
download files to that bts-specific directory. Perform this procedure only
if the CDF files have not been previously loaded.
Table 3-9: Downloading Site Specific BTS Files
Step Action
NOTE
The types of files that can be downloaded include calibration files (.cal extension) and CDF files
(.cdf extension). Files may be compressed (indicated by a .Z extension).
1 Obtain the 3.5-in. diskette(s) containing the configuration data file and calibration data.
2 Enter the following UNIX command from the /usr/lmf directory, to create a BTS specific
directory (if it does not already exist).
mkdir bts-<bts#>
3 Enter the following UNIX command to change to the newly created directory:
cd bts-<bts#>
4 Insert the first 3.5 inch floppy diskette. Verify disk is loaded with the proper BTS files/ versions by
typing the following at the
(lmf): prompt:
seedisk <cr>
5 To load the BTS files from the disk into the appropriate directory, enter the following at the (lmf):
prompt:
fromdisk <cr>
NOTE
Copy bts-#.cdf and (if they exist) bts-#.cal files to the /usr/lmf/bts-# directory. (# equates
to the actual BTS site number).
Unless sites use different device loads, create links to device files (as described in Table 3-10)
rather than placing individual copies into each bts directory.
6 If files are compressed, use the uncompress *.Z command to unpack files.
Download Files to the LMF - Master-bts-cdma Files
These procedures must be followed prior to an initial BTS optimization,
or anytime a new release of the BTS operating system software is to be
loaded from the LMF to the BTS.
Follow the steps outlined in Table 3-10 to create a bts-master-cdma
directory, to download files, and to create softlinks to the device load
files into the appropriate
bts- <bts#> subdirectory. (Always consult
latest software release notes as this is an interim procedure and is subject
to change).
3