User Manual
Index
68P09255A57-2
PRELIMINARY
Aug 2002
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
Index-7
RS-232 to GPIB Interface, 1-12
Rubidium Standard Timebase, 3-64
RX, antenna VSWR, test data sheets, A-18
RX and TX paths fail, Troubleshooting, RFDS, 6-34
S
SC 4812 BTS Optimization/ATP Test Matrix, B-4
SC 4812ET BTS Combiner, H-9, H-10, H-17, H-18,
H-19, H-20, H-22, H-23, H-25
SCLPA, convergence test data sheets, A-9
Selecting Test Equipment, 3-85
Set Antenna Map Data, 3-123
Set RFDS Configuration Data, 3-124
Set Span Parameter Configuration, procedure, 5-8
Setting Cable Loss Values, 3-94
Setting Control Port, 3-6
Setting Coupler Loss Value, 3-95
SGLI2, board detail, MMI port connections, 5-7
SIF, output considerations vs BBX gain set point, C-2
Site, equipage verification, 3-4
Site checklist, verification data sheets, A-3
site equippage, CDF file, 3-3
Site Specific BTS Files, 3-28
Span Framing Format
configure, 5-8
verify, 5-6
SPAN I/O Functional Description, Introduction, H-14
Span Line (T1/E1) Verification Equipment, 1-15
Span Line connector , 6-24
Span Parameter Configuration
set, procedure, 5-8
verification, procedure, 5-6
Span Problems no control link, Troubleshooting, 6-46
SPANS LED, 6-41
Spectrum Analyzer, 1-15
Spectrum Analyzer , HP8594E, 3-64
STATUS LED, GLI, 6-41
SYNC Monitor Connector, CSM, 6-40
System Connectivity Test, F-7
T
T1, isolate BTS from the T1 spans, 3-5, 3-14
Telco Interface Board TIB, 1-30
Test data sheets
Alarm verification, A-19
general optimization checklist, A-6
GPS receiver operation, A-7
initial power tests, A-5
LFR receiver operation, A-8
pre-power tests, A-5
preliminary operations, A-4
RX antenna VSWR, A-18
SCLPA convergence, A-9
site checklist, A-3
TX antenna VSWR, A-16
TX BLO, A-10, A-15
verification of test equipment used, A-2
Test equipment, verification data sheets, A-2
Test equipment connections , F-3
preliminary Agilent E4406A/E4432B set-up, F-15
Test Equipment Policy, 1-8
Test Equipment Setup Calibration for TX Bay Level
Offset, 3-93, F-20
Test Equipment Setup Chart, 3-66
Test equipment setup RF path calibration, 3-103
Timing Reference Cables, 1-13
Transmit TX path audit, 3-109
Transmit TX path calibration, 3-104
Transmit/Receive Module TRX, 1-29
Troubleshooting
DC Power Problems, 6-30
Span Problems no control link, 6-46
Troubleshooting Forward Link Failure (BTS Passed
Reduced ATP), 6-12
TSU NAM, programming
description, 3-120
parameter ranges, 3-122
parameters, 3-121
procedure, 3-128
TX
antenna VSWR, test data sheets, A-16, A-19
BLO test data sheets, A-10, A-15
TX and RX Frequency vs Channel , D-4
TX Audit Test, 3-110
TX Bay Level Offset and TX ATP test equipment
setup calibration, 3-92