User Manual

Index
68P09255A57-2
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
PRELIMINARY
Aug 2002
Index-2
Numbers
10BaseT/10Base2 Converter, 1-12
2-way Splitter, 1-15
3-Sector Duplexed Directional Coupler to RFDS
Cabling Table, H-23
4812ET RF Cabinet Internal FRU Locations, H-4
6-Sector Duplexed Directional Coupler to RFDS
Cabling Table, H-24
A
Acceptance Test Procedures ATP , 1-3
Acronyms, 1-16
ACTIVE LED
GLI, 6-41
MCC, 6-44
Advantest R3465, 3-64
GPIB, I-9
Alarm and Span Line Cable Pin/Signal Information,
3-8
ALARM LED, GLI, 6-41
Alarm Monitor window, 3-130
Alarm Reporting Display, 3-130
All Cal/Audit Test, 3-113
All inclusive, TX ATP test outline - CCP shelf 1,
primary, 4-18
All tests fail on a single antenna, Troubleshooting,
RFDS, 6-35
AMR, 1-21
Applying AC Power, 2-6
ATP
generate failure report, 4-17
generate report, 4-17
test matrix/detailed optimization, B-3
ATP - Reduced, 4-3
ATP Report, 4-18
ATP Test Procedure, 4-9
B
Basic Troubleshooting Overview, 6-2
Battery Charge Test (Connected Batteries), 2-12
Battery Discharge Test, 2-12
Bay Level offset calibration failure, 6-10
BBX, gain set point vs SIF output considerations, C-2
BBX2, 1-21
BBX2 Connector, 6-25
BBX2 LED Status Combinations, 6-43
Broad Band Receiver. See BBX
BTS
download, 3-42
Ethernet LAN interconnect diagram, 3-25
LMF connection, 3-12, 3-24
system software download, 3-3
BTS Cabinet, 1-28
BTS directory, create, 3-28
Create CAL File, 3-114
C
C-CCP Backplane, H-7
C-CCP Backplane Troubleshooting, Procedure, 6-26
C-CCP shelf, 1-21
cable calibration, automatic, test set-up, 3-72
Advantest R3267/R3562, 3-72
Advantest R3465, 3-71
Agilent 8935, 3-71
Agilent E4406A/E4432B, 3-72
CyberTest, 3-71
HP 8921A, 3-71
Cables Connection for 10 MHz Signal and GPIB ,
F-4, F-6
Calibrate BLO, 3-98
Calibrating Cables, 3-90
Calibrating Test Cable Setup, PCS Interface
HP83236B, F-16
Calibrating Test Equipment, 3-89
Calibration
data file calibration, BLO, 3-100
In-Service, G-18
power meter, Gigatronics 8542B, F-25
Calibration Audit failure, 6-11
calibration data file, description of, BLO, 3-100
Cannot communicate to Communications Analyzer,
6-5
Cannot communicate to Power Meter, 6-4
Cannot Download DATA to any device card, 6-6, 6-7
Cannot ENABLE device, 6-8
Cannot Log into cell-site, 6-3