User Manual

GPIB68P09255A57-2
Aug 2002
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
PRELIMINARY
I-9
Table I-7: Verify and Change Advantest R3267 GPIB Address
Step Action
1 If the REMOTE LED is lighted, press the LCL key.
- The LED turns off.
2 Press the CONFIG key.
- The CONFIG softkey labels will appear in the softkey label display area of the instrument
display.
- The current GPIB address will be displayed below the GPIB Address softkey label.
3
3a
If the current GPIB address is not set to 18, perform the following to change it:
- Press the GPIB Address softkey.
-- A GPIB Address entry window will open in the instrument display showing the current
GPIB address.
3b
- Enter 18 on the keypad in the ENTRY section of the instrument front panel.
-- Characters typed on the keypad will replace the address displayed in the GPIB Address
entry window.
NOTE
To correct an entry, press the BS (backspace) key at the lower right of the keypad to delete one
character at a time.
3c - Press the ENTR key to the lower right of the keypad to enter the address.
-- The GPIB Address entry window closes.
-- The new address is diplayed in the bottom portion of the GPIB Address softkey label.
Figure I-7: Setting Advantest R3267 GPIB Address
o
n
REMOTE
LED
LCL Key
CONFIG
Key
Softkey Lable
Display Area
Softkey
Buttons
Keypad BS
Key
ENTR
Key
Advantest R3562 Signal Generator GPIB Address
Set the GP-IB ADDRESS switch on the rear of the Advantest R3562
signal generator to address 1 as shown in Figure I-8.
I