User Manual
GPIB
68P09255A57-2
Aug 2002
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
PRELIMINARY
I-2
GPIB
GPIB Introduction
Use the procedures in this appendix to verify and/or change the GPIB
addresses of the applicable test equipment.
HP437 Power Meter GPIB Address
Follow the steps in Table I-1 to verify and, if necessary, change the
HP437 GPIB address.
NOTE
This procedure assumes that the test equipment is set up and
ready for testing.
Table I-1: Verify and/or Change HP437 Power Meter GPIB Address
Step Action
1 Press Shift and PRESET (see Figure I-1).
2 Use the arrow key to navigate to HP-IB ADRS and press ENTER.
The HP-IB address is displayed.
NOTE
HP-IB is the same as GPIB.
3 If the current GPIB address is not set to 13, perform the following to change it:
- Use the arrow keys to change the HP-IB ADRS to 13.
- Press ENTER to set the address.
4 Press Shift and ENTER to return to a standard configuration.
Figure I-1: HP437 Power Meter
ENTER
PRESET
SHIFT (BLUE) PUSHBUTTON -
ACCESSES FUNCTION AND
DATA ENTRY KEYS IDENTIFIED
WITH LIGHT BLUE TEXT ON
THE FRONT PANEL ABOVE
THE BUTTONS
FW00308REF
I