User Manual

Intra-Cabinet Cabling
68P09255A57-2
Aug 2002
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
PRELIMINARY
H-2
Intra-Cabinet Cabling
SC 4812ET Intra-Cabinet Cabling
This appendix provides the identification and location of the cables
connecting the components which make up the SC 4812ET RF cabinet.
The number of cables and components incorporated in the RF cabinet
will vary depending on the the manner in which the cabinet is equipped.
For example, a 3 sector, 2 carrier system will require less components
and less cables than a 6 sector 2 carrier system.
Refer to Table H-1 and Figure H-1 through Figure H-19 for the cable
you wish to research.
NOTE
In some cases cables with the same number are used to connect
two different signalling paths. These cables are designated A &
B and the point they connect to and from is also designated A &
B. Ensure the correct cable (A or B) is connected to the correct
designation (A or B) connector or plug.
Table H-1: SC4812ET RF CABINET INTER-CONNECT CABLES
DRDC, Combiner, Trunking Backplane Cables
CABLE # FROM NOTE’s TO
3064795A05 TX CIO Figure H-6 Trunking BP
3064735A10 TX Trunking BP Figure H-5 Combiner Connector Pnl
3064735A07 TX Combiner
See Figure H-1, Figure H-11,
Figure H-12, Figure H-13, and
Figure H-14
DRDC
3064735A11 TX Combiner (See Above) DRDC
3064735A12 TX Combiner (See Above) DRDC
3064795A07 TX CIO Figure H-11 Trunking BP
3086435H01 TX Combiner QDS PkZ Adptr
3086435H02 TX Combiner QDS PkZ Adptr
3086435H03 TX Combiner QDS PkZ Adptr
3086168H01 Power LPA PDA Figure H-5 Trunk BP
C-CCP Cables
CABLE # FROM NOTE’s TO
3064809A01 Power CCCP/PDA See Figure H-1 & Figure H-5 C-CCP Backplane
3064899A04 LAN I/O A in See Figure H-1 & Figure H-5 C-CCP LAN I/O A In
C-CCP Cables (cont)
CABLE # FROM NOTEs TO
3064899A04 LAN I/O B in See Figure H-1 & Figure H-5 C-CCP LAN I/O B In
3086033H03 GPS Surge Arrestor See Figure H-1 & Figure H-5 C-CCPBackplane
3064899A04 LAN I/O B in See Figure H-1 & Figure H-5 C-CCP LAN I/O B In
. . . continued on next page
H